B&M Fab Polaris PRO-RIDE Exo Front Bumper

By BM Fab


B&M Fab Polaris PRO-RIDE Exo Front Bumper - RAW is backordered and will ship as soon as it is back in stock.

  • 2011-2015 Polaris Pro RMK 155"
  • 2011-2015 Polaris Pro RMK 163"
  • 2011-2015 Polaris Pro RMK Assault 155"
  • 2011-2016 Polaris Switchback Assault 144" (will need the RMK block off plates to close off the holes in the hood)

This is B&M Fabs EXO front bumper for the Pro Ride. Built off the same proven design as their previous pro bumper. If you have broken the factory mounting tabs off your overstructure, you're in luck! By bolting the bumper to the overstructure itself, they eliminated the need for the factory tabs. The rear bumper mounts have been beefed up this year. They also eliminated the front center bumper mount. We have seen that this mount will only increase damage to the sled, (mainly the pipe) when involved in a front end hit. By getting rid of that mount, they increased the crush zone of the bumper to cut down on pipe damages from minor impacts. They sucked the lower tubes that tie directly into the bulkhead even closer to the plastics for a much more refined and sleek look as well as less intrusive.

Built from 1" OD 1/8" Wall 6061 T4 USA made tubing.

Hand assembled and TIG welded right here in America!

NO trimming of the plastics is required to mount this bumper, just two holes in the bottom of bulkhead and a drilling template and hardware is included.

Works with Polaris style skid plates.


Please note directions below are for the old bumper but the install is still exactly the same. Check them out!